| Bugattibuilder.com forum http://www.bugattibuilder.com/forum/ |
|
| Bugatti part . http://www.bugattibuilder.com/forum/viewtopic.php?f=1&t=2439 |
Page 1 of 1 |
| Author: | Udolahr [ Sun May 29, 2011 1:38 pm ] | ||
| Post subject: | Bugatti part . | ||
What is the name in English for this part . It is not so easy to make if you like to have it perfect straight and exact like in the drawing . I had to make some special tools for it . The part at the right is an original .
|
|||
| Author: | Herman [ Sun May 29, 2011 4:56 pm ] |
| Post subject: | Re: Bugatti part . |
A yoke? (not a joke) |
|
| Author: | Udolahr [ Sun May 29, 2011 5:30 pm ] |
| Post subject: | Re: Bugatti part . |
like a clutch bearing yoke ? |
|
| Author: | Herman [ Sun May 29, 2011 6:13 pm ] |
| Post subject: | Re: Bugatti part . |
Possibly, "yoke" is very general. It can be about anything with a forked shape. |
|
| Author: | Udolahr [ Sun May 29, 2011 6:18 pm ] |
| Post subject: | Re: Bugatti part . |
yoke in german is Joch . A Joch can be anything . Or a Joch is something , what keeps somthing in place . |
|
| Author: | Udolahr [ Wed Jun 08, 2011 11:54 pm ] | ||
| Post subject: | Re: Bugatti part . | ||
I think it looks very original .
|
|||
| Author: | Udolahr [ Thu Jun 16, 2011 5:59 pm ] | ||
| Post subject: | Re: Bugatti part . | ||
first one is ready . The top one is original . Tube 22mm x inside 14mm
|
|||
| Author: | nicefloor [ Thu Jun 16, 2011 9:54 pm ] |
| Post subject: | Re: Bugatti part . |
Udo - looks good. What did you use to cut the slit in the tubing? Just curious. Dan |
|
| Author: | Udolahr [ Fri Jun 17, 2011 3:18 am ] |
| Post subject: | Re: Bugatti part . |
in a milling machine . disk diameter 80mm , 2,5mm wide , 50 tooth. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|