How is the center tube conected with the autside spring hänger ?
| Attachments: |
|
CIMG3196.JPG [ 238.49 KiB | Viewed 8694 times ] |
| Bugattibuilder.com forum http://www.bugattibuilder.com/forum/ |
|
| Question ? http://www.bugattibuilder.com/forum/viewtopic.php?f=1&t=2483 |
Page 1 of 1 |
| Author: | Udolahr [ Wed Jul 06, 2011 11:58 pm ] | ||
| Post subject: | Question ? | ||
How is the center tube conected with the autside spring hänger ?
|
|||
| Author: | Greg Morgan [ Thu Jul 07, 2011 9:06 am ] |
| Post subject: | Re: Question ? |
A bolt goes through the spring hanger and the tube. Remove the spring and you will see it. Thought you would know that. |
|
| Author: | Udolahr [ Thu Jul 07, 2011 11:30 am ] |
| Post subject: | Re: Question ? |
can you show any foto how it looks ? Has the bolt a counter sunk head , so the spring hanger is flat underneath ? What diameter can it be , like 8mm ? Has the inside tube a thread or is a nut inside ? |
|
| Author: | Greg Morgan [ Thu Jul 07, 2011 4:58 pm ] |
| Post subject: | Re: Question ? |
Both spring hanger and tube has a thread. |
|
| Author: | Udolahr [ Thu Jul 07, 2011 6:19 pm ] |
| Post subject: | Re: Question ? |
counter sunk ? 8 or 10 mm ? Foto shows T28 |
|
| Author: | Lazarus [ Fri Jul 08, 2011 10:50 am ] |
| Post subject: | Re: Question ? |
Udolahr wrote: counter sunk ? 8 or 10 mm ? Foto shows T28 14mmX 1.25P |
|
| Author: | Udolahr [ Fri Jul 08, 2011 11:16 am ] |
| Post subject: | Re: Question ? |
OK , 14mm . What about the counter sunk head ? Or is a hole in the spring for the bolt head ? |
|
| Author: | Udolahr [ Sun Jul 10, 2011 9:04 pm ] |
| Post subject: | Re: Question ? |
T44 , T50, T41 has a rivet with a counter sunk head . |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|